Apply:
Before you begin, make sure your eye area is clean, oil-free, and that you've completed a patch test to ensure you're not allergic to our bond.
Step 1:
Apply a small amount of bond to the base of your natural lashes.
Then apply a small amount of bond to the band of the cluster lash.
Wait about 20 seconds until the bond becomes tacky.
Step 2:
Gently use the applicator or your fingers to pinch the band of the cluster and remove it from the tray.
Step 3:
Use the applicator to hold the tip of the cluster lash (to avoid touching the bond on the band or your natural lashes).
Place the cluster underneath your natural lashes, making sure the band is at least 1mm away from your waterline to avoid any discomfort or stinging.
Repeat the steps until one eye is complete.
Step 4:
Lightly apply seal over the areas where bond was applied.
Then apply a little seal onto the applicator and gently press your natural lashes and clusters together to secure them.
* Always make sure your applicator is clean and free of any glue residue before each use.
Removal:
Apply the remover from the kit onto the lashes, making sure they are fully saturated.
Wait for 30 seconds, then gently pull off the clusters with your fingers.
If there's any glue residue left on your natural lashes, apply more remover and wipe it off with a cotton pad.
Read the Privacy Policy
